Hello folks
I have acquired 10 none working hp Planar Pl1700 monitors, so far I repaired 5 monitors all with bulging caps on power supply. But I noticed allot of the caps on logic boards tested out of specs from 2.00 ohms to 4.50 ohms, caps are 220uf 16v 85c Lelons after repairing 5 of the 10 monitors with out replacing caps on logic board all 5 work fine no odd symptoms.
What would the symptoms be with high esr caps on logic board since ccfl are bad. I tested with good ccfl all light up.
On the nest 5 monitors should I us 85c caps or 105c
I have acquired 10 none working hp Planar Pl1700 monitors, so far I repaired 5 monitors all with bulging caps on power supply. But I noticed allot of the caps on logic boards tested out of specs from 2.00 ohms to 4.50 ohms, caps are 220uf 16v 85c Lelons after repairing 5 of the 10 monitors with out replacing caps on logic board all 5 work fine no odd symptoms.
What would the symptoms be with high esr caps on logic board since ccfl are bad. I tested with good ccfl all light up.
On the nest 5 monitors should I us 85c caps or 105c
Comment