Announcement

Collapse
No announcement yet.

Condenser tumble dryer component id

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Condenser tumble dryer component id

    Any idea what ohm this resistor should be?
    Reads, in-circuit, 2.2ohm with board disconnected but looking it up should be a 270ohm resistor. My eyes are seeing 4 bands - yellow,violet,brown,gold.

    The components either side of it read higher values so don't see the need to remove from the circuit i.e diode, caps and resistors seem ok.

    And what wattage is this likely to be? 3W

    Thanks
    Attached Files
    Last edited by notallbad; 09-05-2020, 07:28 AM.

    #2
    Re: Condenser tumble dryer component id

    that's an inductor, if it has low resistance then it's o.k.

    Comment


      #3
      Re: Condenser tumble dryer component id

      Out of circuit the resistor reads 2.2 ohm, same as in circuit.

      It must be a 2.2 ohm res, if it was bad it would be open circuit, not shorted! Right?

      Thanks, just saw your post. And oh yes. just noticed the L003 ref on the board too, doh!
      Last edited by notallbad; 09-05-2020, 08:50 AM.

      Comment


        #4
        Re: Condenser tumble dryer component id

        It is a 470 microhenry coil, NOT a resistor, the 2.2Ω is likely your meter leads plus the inductor DC resistance which is likely under 1Ω.

        Comment

        Working...
        X