hey there,
specific questions:
so i have gtx 1070 which isnt detected where the caps, inductors and mosfets are short. Circled red. can i just inject voltage in the red circled pads? if yes, how much volt and amps are safe?
general question:
is there a tutorial on how to proceed with an defective graphics card? like check this first, then this, then this.if this component is falty it means that, or also something else could be bad etc.?
i know there are differnt rails and so on but these are on different places depneding on the board layout. how to find out where they are? i poked around a bit and it seems there is only 16V? present.
best regards
https://imgur.com/a/sZZkY3s
specific questions:
so i have gtx 1070 which isnt detected where the caps, inductors and mosfets are short. Circled red. can i just inject voltage in the red circled pads? if yes, how much volt and amps are safe?
general question:
is there a tutorial on how to proceed with an defective graphics card? like check this first, then this, then this.if this component is falty it means that, or also something else could be bad etc.?
i know there are differnt rails and so on but these are on different places depneding on the board layout. how to find out where they are? i poked around a bit and it seems there is only 16V? present.
best regards
https://imgur.com/a/sZZkY3s
Comment