I have a 40'' TV using the cursed 17MB82S board and my problem was the "red light flashing". I found a pre-used 17MB82S near me and i decided to buy it from e-bay. When i put it on the TV worked just to find out the picture was upside-down and the resolution 800X600 or lower. Then i checked the card i bought and it wasn't exactly the same in fact it was for 42'' TV. I couldn't solve this even from the service menu. Anyone knows if i can reprogram the board to work with my 40''. set?
Announcement
Collapse
No announcement yet.
Difficult question for 17MB82s
Collapse
X
-
Re: Difficult question for 17MB82s
You have to flash the exact firmware for you tv by usb, or use a programmer and program a dump that fits your chassis+screen.You need a soldering gun and a programmer. The memory chips in the 17MB82S are usually U10 and U12. Also have in mind that you might have no reception or audio based on the dumps that you use. If you cannot find help elsewhere I can order the firmware by usb for 10$.Last edited by ducky29; 02-21-2019, 05:48 AM.
Comment