![]() |
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Hi all
Seems that the CD reader had failed . Could only find it listed on Ebay via Liberty Electronics . Have bought from them before & been quite reliable . Quite an expensive part & wondering if there are any other suppliers in UK , or Europe so that i can save on post . https://www.ebay.co.uk/itm/282281869568 |
![]() |
![]() |
![]() |
#2 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() CD reader arrived , but thought before i fit ,will check caps on the servo board .
Replaced several with poor readings . Now for the reader . |
![]() |
![]() |
![]() |
#3 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Reader fitted & on test with a music CD
|
![]() |
![]() |
![]() |
#4 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() A few other issues with this unit .
On occasion when tray ejected , it would retracted by itself . Pulled tray out to access the detect switch , & cleaned with IPA Also the FRONT speaker audio would cut out intermittently . Discovered the top 2 speaker protect relays corresponding to FRONT were dry jointed at the coil side . |
![]() |
![]() |
![]() |
#5 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Remote control not working either .
Once stripped down issue was self evident . Glue once used to secure the 8MHZ oscillator had become corrosive . A replacement restored operation . |
![]() |
![]() |
![]() |
#6 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Play back was still a touch temperamental .
To resolve this removed turntable motor & sprayed some IPA through the underside onto brushes . |
![]() |
![]() |
![]() |
#7 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Yet again from a cold start , after being off for a day , it wouldn't play .
Took a hair drier to the PSU module , then sprang into life again . Time for more cap replacements i think . |
![]() |
![]() |
![]() |
#8 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() One cap found with a very poor ESR reading , C5012 ( 10MF , 50V )
Hopefully this is the cause . |
![]() |
![]() |
![]() |
#9 |
Badcaps Veteran
Join Date: Apr 2011
Posts: 293
|
![]() Powered , tested from cold start on two consecutive mornings & all good so far .
|
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|