I thought I would ask around since my searches didnt turn up much. I am replacing some filter caps in an amp, and cant find the ones I want. I thought since this seems to be you guys passion you might know some good supply sources.
The originals are Capxon 35v 1000uF radial about 12.5x22mm. The ones I want are Rubycon, matching if possible. Anyway, I cant find them but I have exstrapolated the model number which should be something like 35SXC1000M13X26 or similar. The convention seems to be: Voltage>Model>Capacitance>Width>Height.
Obviously the voltage, and capacitance can be higher, but I would like to keep my cost fairly low. Unfortunately the dimentions are (slightly) critical since they are butted together on the pcb. They are about 12.5 or 13mm wide, and about 22 or 23mm high. The suitable model numbers out of the 2010 Rubycon catalog are SXG, SXC, SXR. These are the Over Voltage Venting models, and is a requirement for this application.
They dont have to be Rubycon, any quality cap that meet the specs should be fine, but I would rather not pay more than a buck ea if I can help it.
Thanks
The originals are Capxon 35v 1000uF radial about 12.5x22mm. The ones I want are Rubycon, matching if possible. Anyway, I cant find them but I have exstrapolated the model number which should be something like 35SXC1000M13X26 or similar. The convention seems to be: Voltage>Model>Capacitance>Width>Height.
Obviously the voltage, and capacitance can be higher, but I would like to keep my cost fairly low. Unfortunately the dimentions are (slightly) critical since they are butted together on the pcb. They are about 12.5 or 13mm wide, and about 22 or 23mm high. The suitable model numbers out of the 2010 Rubycon catalog are SXG, SXC, SXR. These are the Over Voltage Venting models, and is a requirement for this application.
They dont have to be Rubycon, any quality cap that meet the specs should be fine, but I would rather not pay more than a buck ea if I can help it.
Thanks
Comment