so i have this board in my build... it started giving me a fan failure notice and the board would turn off....
i switched the fans 3 times still gave me an error...so i looked at the caps and 1 was bulged.i replaced it (100UF, 6.3V)and i benched tested the board and it worked slowly...found a better cap( Rubycon ) and it worked faster...
then i shut off the system...
came back to it an hour later and the system turned on by itself...
*** bench tested with a Antec 350w ps 1 g ddr2 an vid card connected to a surge protector***
Now the board stays on a soon as i plug the ps on .... tried 2 ps sill same results...it wont post unless i also flip the PSW switch...then it works ok...
any suggestions..
i switched the fans 3 times still gave me an error...so i looked at the caps and 1 was bulged.i replaced it (100UF, 6.3V)and i benched tested the board and it worked slowly...found a better cap( Rubycon ) and it worked faster...
then i shut off the system...
came back to it an hour later and the system turned on by itself...
*** bench tested with a Antec 350w ps 1 g ddr2 an vid card connected to a surge protector***
Now the board stays on a soon as i plug the ps on .... tried 2 ps sill same results...it wont post unless i also flip the PSW switch...then it works ok...
any suggestions..