Hi,
I replaced all the 1000 and 1500 uF caps on my VP6 and now it won't post normally with 2 CPUs. It posts normally with 1 CPU (it doesn't matter which of the two CPUs or in which socket).
If I reset the BIOS settings it reluctantly starts with two cpu's (after a couple of resets) but as soon as I try to save the correct setting from BIOS and restarts it refuses to post.
I've had similar problems before recapping, always had to reset once after power up. But after that it ran normally (with the occasional system freeze once a week or soo). This was the problem i was trying to fix...
Update: I found out it posts "reliably" with fsb's up to 115 with 2 cpu's. (The CPU's are 1000/133mHz ones)
Any ideas of whats going on? Is it fixable?
Thanks,
Johannes
I replaced all the 1000 and 1500 uF caps on my VP6 and now it won't post normally with 2 CPUs. It posts normally with 1 CPU (it doesn't matter which of the two CPUs or in which socket).
If I reset the BIOS settings it reluctantly starts with two cpu's (after a couple of resets) but as soon as I try to save the correct setting from BIOS and restarts it refuses to post.
I've had similar problems before recapping, always had to reset once after power up. But after that it ran normally (with the occasional system freeze once a week or soo). This was the problem i was trying to fix...
Update: I found out it posts "reliably" with fsb's up to 115 with 2 cpu's. (The CPU's are 1000/133mHz ones)
Any ideas of whats going on? Is it fixable?
Thanks,
Johannes
Comment