I have a 19" General Touch monitor that does the 2 seconds then black thing.
The monitor only has 2 boards. An A/D-logic board and an inverter board.
I have replaced both boards with new ones and I still have 2 seconds then black.
Reading the sticky I'm not sure how to test the cfl's. The inverter board has 4 2 pin conectors. Do each of these power 1 lamp? Can all 4 of my lamps be bad?
Sorry if these are dumb questions, I have very little experience with LCD monitors.
The monitor only has 2 boards. An A/D-logic board and an inverter board.
I have replaced both boards with new ones and I still have 2 seconds then black.
Reading the sticky I'm not sure how to test the cfl's. The inverter board has 4 2 pin conectors. Do each of these power 1 lamp? Can all 4 of my lamps be bad?
Sorry if these are dumb questions, I have very little experience with LCD monitors.
Comment