Re: Makita 440 Cap types?
Check the large resistor and if it is not open, you might be able to solder back to the leads where you cut them, or add some wire around the leads and still use it
I don't know where you got that resistor number The value is 0.47 ohm 10watt 5%
This is the closest I could find here:
CPC number is RE06460, Welwyn W24-0R47 JI You may need to check its dimensions to see if it will fit
RS 666-1692 (C10R47JL) (min quantity 5)
The triac is STP16A60 There is another number after the `6' (16 amp 600 volt triac)
This Sanken number looks close TMA166G-L
or Renesas BCR16CM-12LB
Check the large resistor and if it is not open, you might be able to solder back to the leads where you cut them, or add some wire around the leads and still use it
I don't know where you got that resistor number The value is 0.47 ohm 10watt 5%
This is the closest I could find here:
CPC number is RE06460, Welwyn W24-0R47 JI You may need to check its dimensions to see if it will fit
RS 666-1692 (C10R47JL) (min quantity 5)
The triac is STP16A60 There is another number after the `6' (16 amp 600 volt triac)
This Sanken number looks close TMA166G-L
or Renesas BCR16CM-12LB
Comment