Somewhere... I don't remember where, but I have a piece of equipment laying around that has SMT caps (not chip type) sitting where a through-hole was meant to be. I guess as long as the solder touches it's okay, right? Is this hard to do or could I mimmick this on pretty much anything?
Announcement
Collapse
No announcement yet.
SMT where through-hole should be?
Collapse
X
-
Re: SMT where through-hole should be?
Sure you can. It's a bit impractical though due to different spacings... i usually scratch copper traces free and use them as pads.
Be sure you don't mix up polarization when using the underside."Every normal man must be tempted at times to spit on his hands, hoist the black flag, and begin slitting throats." - H.L. Mencken
Comment