Hi all, Hope everyone is well. Need some help please.
I have a Blade BM7000s SAT receiver that is determined to be a PSU issue.
There is an issue that could happen known as the 'blinking red light'
and a software/reset type solution works in many cases and if not
it is determined as a PSU problem.
Those who have had their PSU replaced or repaired then have working units again.
Mine is the aforementioned PSU problem.
I have uploaded 2 start up pics for starting purposes.
I have replaced a 47uf 450v (large brown) and 100uf cap (marked red)as they were laying around but the problem is still there.
I have tested the power output points and only the 5v (marked red) has power, with the ctl (marked red)also having 3v.
The rest have nothing.
As the front red led is blinking, there is a buzzing noise that is also present that syncs with the led flashes. Higher buzz with led on and lower when blinking off.
I would welcome any advice or clues. Thank you
I have a Blade BM7000s SAT receiver that is determined to be a PSU issue.
There is an issue that could happen known as the 'blinking red light'
and a software/reset type solution works in many cases and if not
it is determined as a PSU problem.
Those who have had their PSU replaced or repaired then have working units again.
Mine is the aforementioned PSU problem.
I have uploaded 2 start up pics for starting purposes.
I have replaced a 47uf 450v (large brown) and 100uf cap (marked red)as they were laying around but the problem is still there.
I have tested the power output points and only the 5v (marked red) has power, with the ctl (marked red)also having 3v.
The rest have nothing.
As the front red led is blinking, there is a buzzing noise that is also present that syncs with the led flashes. Higher buzz with led on and lower when blinking off.
I would welcome any advice or clues. Thank you
Comment