Probook 450 G2 LA-B181p, ME clean request

[poster1]

Hello!
Please clean ME Region in my bios dump.

Probook 450 G2 LA-B181p

Thanks in advance

[hardware1]

Originally Posted by poster1

Hello!
Please clean ME Region in my bios dump.

Probook 450 G2 LA-B181p

Thanks in advance

Your file is not complete, try to read it again.
Why you need clean me?

[poster1]

1)Device autostarts when AC adapter is connecter
2)Shows display after ~30s

CMOS bat is 3.3V and bios settings are correct.

Here is correct dump

[hardware1]

Originally Posted by poster1

1)Device autostarts when AC adapter is connecter
2)Shows display after ~30s

CMOS bat is 3.3V and bios settings are correct.

Here is correct dump

Try the first bios with only clean me, if the problem still present try the other one (the new file).

[poster1]

Thank You, XM25QH64A (ME Cleaned) works fine

[Joztu]

Hello house, please i need help with the BIOS file for HP 450 G2

the laptop comes on sometimes while other times it doesn't, i programmed 2 other BIOS found on this site, for first one, the HDD was not recognized in BIOS setup while for the second, it gave an error message "broadcom was not supported"


Board number: ZPL40-ZPL50-ZPL70 LA-B181P Rev 1.0

the backup BIOS is attached here

[farouk_1994]

Originally Posted by Joztu

Hello house, please i need help with the BIOS file for HP 450 G2

the laptop comes on sometimes while other times it doesn't, i programmed 2 other BIOS found on this site, for first one, the HDD was not recognized in BIOS setup while for the second, it gave an error message "broadcom was not supported"


Board number: ZPL40-ZPL50-ZPL70 LA-B181P Rev 1.0

the backup BIOS is attached here

Try than replay extracted form hp website with your laptop serial number

[Joztu]

Originally Posted by farouk_1994

Try than replay extracted form hp website with your laptop serial number

i'll give it a try and revert with status, thanks

[Joztu]

Originally Posted by farouk_1994

Try than replay extracted form hp website with your laptop serial number

hello, thanks, it worked but..... I was getting an error of "product information invalid" and I really didn't know how to go about it


Thanks though

[farouk_1994]

Originally Posted by Joztu

hello, thanks, it worked but..... I was getting an error of "product information invalid" and I really didn't know how to go about it


Thanks though

did you solve it or not yet.???