I'm getting a blink code which indicates a lamp problem. Following guidance I see on YouTube etc, the suggestion is to re-set the lamp failure counter before going too far further. I use the technique described in Sharp service manual to enter Service Mode (hold down INPUT and VOL DOWN key simultaneously then power up) and it seems to half get there before shutting down again. The Power LED goes through a different sequence than standard start up, a brief flash from the backlights, audio static burst, then it shuts down again.
Do you reckon things are too far gone and the set is shutting down even in Service Mode to protect itself?
Thoughts please?
Do you reckon things are too far gone and the set is shutting down even in Service Mode to protect itself?
Thoughts please?
Comment