Hi And thanks for reading this post. I am going to replace the stock 10kuf caps in the power supply of an amplifier and have been told it is better to parallel a few smaller caps rather than using one large cap. Apparently one big 10kuf cap is slow to charge and discharge and gives a slow kind of sound. Tried googling this point but cannot find it anywhere. Do you think it could be true.
Also I was going to purchase low esr caps but have been told that this will not make a difference with the 50hz mains ac, that low esr caps only make a difference at high frequencies such as smps
Any information on either of these two points will be most appreciated.
Also I was going to purchase low esr caps but have been told that this will not make a difference with the 50hz mains ac, that low esr caps only make a difference at high frequencies such as smps
Any information on either of these two points will be most appreciated.
Comment