Announcement

Collapse
No announcement yet.

Replacement for CapXon LP

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Replacement for CapXon LP

    From a DLP power board. 200V 470uf, ripple is 2230mArms

    I can't seem to find anything close enough. Close enough decent quality I found was UCC EK, at 1770mArms

    diameter 25
    Cap Datasheet Depot: http://www.paullinebarger.net/DS/
    ^If you have datasheets not listed PM me

    #2
    Re: Replacement for CapXon LP

    85°C caps allow higher current.
    look for those.

    if you can't find any ask manufacturer for advice.
    Because in some cases some 105°C caps can endure higher current but must be treated as a 85°C one in that case.

    Comment


      #3
      Re: Replacement for CapXon LP

      might have found one
      https://cdn.badcaps-static.com/pdfs/...8344553467.pdf

      not sure about the leakage current though
      Cap Datasheet Depot: http://www.paullinebarger.net/DS/
      ^If you have datasheets not listed PM me

      Comment


        #4
        Re: Replacement for CapXon LP

        I've found something cheaper:

        https://www.mouser.de/ProductDetail/...mLf3dAMEETU%3d
        https://www.mouser.de/ProductDetail/...FpJyP7yEJtA%3d

        The others I've found don't seem to be available.

        Comment


          #5
          Re: Replacement for CapXon LP

          zero available. and the ripple is at most 1970mArms. The one i'm replacing with is 2.2Arms
          Last edited by Uranium-235; 01-29-2018, 10:20 PM.
          Cap Datasheet Depot: http://www.paullinebarger.net/DS/
          ^If you have datasheets not listed PM me

          Comment


            #6
            Re: Replacement for CapXon LP

            CapXon's are fucking overrated. Just go with a quality Japanese brand and don't think of it no more.

            I had same problem when looking for some smaller Su'scon caps for an audio amp. Couldn't find a single reputable Japanese manufacturer that had a cap that met the specs of those Su'scons. So in the end, I just said, "f- this" and got some Rubycon YK and Nichicon VZ general purpose caps that were more or less close enough in specs to the Su'scons. After all, the Su'scons were GP caps too, so there's no way it could have mattered. And it didn't. The repair worked without a hitch and been working fine for a long time now.

            Comment

            Working...
            X