Announcement

Collapse
No announcement yet.

FYI.. Vizio M49-C1

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    FYI.. Vizio M49-C1

    Just an FYI.. The voltages labeled at CN9101/CN9102 on the power supply (ADTVE1825AC7) are incorrect. all the +12V are actually 19V. I spent hours trying to figure this out and even swapping out another PS that had matching pin outputs with the correct 12V. a pic of the board from shopjimmy attached

    Found this TV at the dump, new with stickers. the screen would work for a few minutes then go all white or red. Turns out the LVDS cable was not completely connected in the TCON causing it to act up. A strip of tape fixed all my issues, it's been running well since then.


    Attached Files
    Craigslist Picks & Fixes

    2 ea - Samsung 52"
    Samsung 60"

    #2
    Re: FYI.. Vizio M49-C1

    Awesome! Will file this under fixed.

    Comment


      #3
      Re: FYI.. Vizio M49-C1

      Those 12V's look to done by Synchronous Rectification (MOSFET Q9111, IC9111), I wonder if there is problem in that section to make it output 19V instead of 12V. You may want to look up the spec sheet of that SMD IC9111 to see how it functions.
      http://citeseerx.ist.psu.edu/viewdoc...=rep1&type=pdf
      The MOSFET is on the low side on that board.
      Last edited by budm; 07-21-2017, 11:29 PM.
      Never stop learning
      Basic LCD TV and Monitor troubleshooting guides.
      http://www.badcaps.net/forum/showthr...956#post305956

      Voltage Regulator (LDO) testing:
      http://www.badcaps.net/forum/showthr...999#post300999

      Inverter testing using old CFL:
      http://www.badcaps.net/forum/showthr...er+testing+cfl

      Tear down pictures : Hit the ">" Show Albums and stories" on the left side
      http://s807.photobucket.com/user/budm/library/

      TV Factory reset codes listing:
      http://www.badcaps.net/forum/showthread.php?t=24809

      Comment

      Working...
      X