I tried to change my old, unfunctional Hakko 808- 5 desoldering tool to extrasensory perception desoldering tool.
Announcement
Collapse
No announcement yet.
Hakko 808 desoldering extrasensory perception tool.
Collapse
X
-
Re: Hakko 808 desoldering extrasensory perception tool.
Best combinations! Best results.
No needs container when using the vacuum because the iron case of the compressor itself is a vacuum container.
I have a question every time I need to turn the valve to make a vacuum suction. Is there any footswitch for a vacuum valve or push on-off valve? I try to keep it simple, don't want to use electronic valve.Last edited by capwizard; 04-02-2019, 11:37 AM.
-
Re: Hakko 808 desoldering extrasensory perception tool.
something like this https://www.veneersupplies.com/produ...-Position.html
There may be similar units cheeper
Or this one: https://www.amazon.com/Air-Mite-Mini.../dp/B00P6XL0T6Last edited by R_J; 04-02-2019, 04:04 PM.
Comment
-
Re: Hakko 808 desoldering extrasensory perception tool.
I appreciate your help. But my budget is only ten dollars. So I eat my words, I will go with this one. Picture1.
One more benefit (3 ways) is I can use the same outlet switch between vacuum and compressed air. Why? So 852D+ could heat up SMD part with hot compressed air then pick up with a vacuum.Last edited by capwizard; 04-02-2019, 05:34 PM.
Comment
-
Re: Hakko 808 desoldering extrasensory perception tool.
Originally posted by capwizard View PostOne more benefit (3 ways) is I can use the same outlet switch between vacuum and compressed air. Why? So 852D+ could heat up SMD part with hot compressed air then pick up with a vacuum.
Because the description says exhaust valve9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had CAPs POOF
All of the mosfet that are taken out by bad caps
Comment
Comment