Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

Gigabyte 7VT600P-RZ?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Gigabyte 7VT600P-RZ?

    anyone recap any Giga 7VT600P-RZ, seems like a nice board but dunno what wrong... replaced some of the caps with some caps from some other dead boards.... it gets to a point where the cpu fan spins, 2 mosfets get 5volt input other 2 get no input no output....

    can anyone tell me of there experience with these boards?

    sidenote, first time I try going any further then replacing caps on a working board:P... little electronics knowledge, good soldering experience:P
    Tags: None
    #2
    Re: Gigabyte 7VT600P-RZ?

    Check for shorted caps..... try new capacitors. Usually a short will shut down the PSU though.....

    Also, check for burned traces and recheck the solder joints.

    Comment

      #3
      Re: Gigabyte 7VT600P-RZ?

      Oh yeah...check the PSU connector.

      Comment

        #4
        Re: Gigabyte 7VT600P-RZ?

        none with this MB

        Suppose the first question was it booting up before you change caps?
        how bad to look at and what brand series were they?

        but yeah recheck work as above if it was booting before hand
        you say you used "used caps?"
        (ideally not a good idea)

        from a photo image I found it uses (I think 2 phase VRM)
        (link for ref only)

        There is usually (for want of the correct technical terms ) a top and bottom Mosfets pairs
        So 2 I think should have voltage but 2 wont have voltage (per say)
        So that sort of sounds right
        are any mosfets getting very hot? per chance

        There can be a few reasons why it wont start up and the state it was in before recap can help work this out.

        So a bit more info might help us help you

        Cheers
        You step into the Road, and if you don't keep your feet, there is no knowing where you may be swept off to." Bilbo Baggins ...

        Comment

          #5
          Re: Gigabyte 7VT600P-RZ?

          it was given to me dead by a friend.... apparently he had it hooked up at the time and running.... he went to go to use his computer and it was off he tried to turn it on but nothing.... series of caps I replaced... don't remember to tell ya;P sorry.... I will say though there is a chance his psu was shotty and may of been the cause

          Comment

            #6
            Re: Gigabyte 7VT600P-RZ?

            just noticed on the backside of the board its a bit yellowed where the mosfets are and same where where the north bridge is...

            guess its done

            Comment

            Previous template Next
            Working...
            X