Good morning everyone, receive a cordial greeting.
I have a brand power source: Winsun Model WS200-3EAC-247
PCB2003EACMAB-V12
This source has multiple voltage outputs. Dual 24vdc sources operate well.
But the session of the power source that delivers 24vdc, 40vdc, 5vdc. it does not work.
When reviewing it, 2IC1 exploded, only the last digits of the code are observed, 44N, I think it is a UC3844N
I must locate the value of several resistors that are burned out and cannot color read and others open.
The Mosfet is short.
The other 1IC1 is different. UC3845B this corresponds to the font that is working fine.
So I can't use that operating session as a reference. (They are different)
I ask you if you have the service diagram of this source, I already looked in the forum and on the internet and I did not get it.
I look forward to your valuable comments.
Thank you very much.
Happy day
I have a brand power source: Winsun Model WS200-3EAC-247
PCB2003EACMAB-V12
This source has multiple voltage outputs. Dual 24vdc sources operate well.
But the session of the power source that delivers 24vdc, 40vdc, 5vdc. it does not work.
When reviewing it, 2IC1 exploded, only the last digits of the code are observed, 44N, I think it is a UC3844N
I must locate the value of several resistors that are burned out and cannot color read and others open.
The Mosfet is short.
The other 1IC1 is different. UC3845B this corresponds to the font that is working fine.
So I can't use that operating session as a reference. (They are different)
I ask you if you have the service diagram of this source, I already looked in the forum and on the internet and I did not get it.
I look forward to your valuable comments.
Thank you very much.
Happy day
Comment