I'm working on a Sharp Aquos exhibiting blink code 2 long & 5 short.
Procedures asks to disconnect the two 80 pin ribbon cables, power on TV and note if the backlight comes on then if there is damage visible to the LCD panel.
I don't want to damage the ribbon cable so I'm asking for the correct procedure to remove the two cables. See attachment below.
Procedures asks to disconnect the two 80 pin ribbon cables, power on TV and note if the backlight comes on then if there is damage visible to the LCD panel.
I don't want to damage the ribbon cable so I'm asking for the correct procedure to remove the two cables. See attachment below.
Comment