Announcement

Collapse
No announcement yet.

lenovo edge E530 white screen

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    lenovo edge E530 white screen

    Hallo.
    Have this Lenovo Edge E530 that boot just to white screen
    reflashed bios, but nothing changed
    tested with known good lcd. when in white screen, brightnes controll work
    also nothing on hdmi

    i realize that +VCC_GFXCORE_AXG is only 0.45v
    i have uma gpu so i dont know it is enough
    Last edited by ktmmotocross; 12-16-2018, 04:29 PM.

    #2
    Re: lenovo edge E530 white screen

    GFXCORE at 0.45V is ok.Check LVDS pinout voltage.

    Comment


      #3
      Re: lenovo edge E530 white screen

      Check the LVDS voltage as @mcplslg123 said ,the LVDS cables fail on these ,and theres problems with flexing around the left hinge, vent .
      All donations to badcaps are welcome, click on this link to donate. Thanks to all supporters

      Comment


        #4
        Re: lenovo edge E530 white screen

        while checking voltages i found this q2102
        ckecked both sides for short
        in little time i dont find that mosfet so i just jumped s-d and picture comes on

        just search on boards for replacement
        Attached Files
        Last edited by ktmmotocross; 12-17-2018, 02:20 AM.

        Comment


          #5
          Re: lenovo edge E530 white screen

          Any SOT-23 P channel mosfet should do as long as its rated at the same or better spec

          https://store.comet.bg/download-file.php?id=6908
          All donations to badcaps are welcome, click on this link to donate. Thanks to all supporters

          Comment


            #6
            Re: lenovo edge E530 white screen

            I'd say change the screen. I had many cases where a white screen came from a defective screen.
            But in your case it is the mosfet.

            Comment


              #7
              Re: lenovo edge E530 white screen

              Remember everyone for any laptop white screen problem

              white screen always come when 3.2 volts not going to any LCD or LED fuse

              All LED have two fuses one have 19 Voltage and One is 3.2

              so you can check voltage on fuse if not showing complete 3.2 then always display will come white screen


              in the upper case you show in pic there is one transistor that is burn from middle just check which pin have 3.2 voltages then just make a jumper to the other side where is only 1 pin

              after the jumper i think your problem will solve

              Comment

              Working...
              X