Calibre 240V/1000W Pure Sinewave Inverter (12V input)
On each of the output transformers at the primary side:
2x HRF3205 MOSFETs on each side of the centre tap
2200uF 16V x2
30A fuse x2
On the isolated secondary side:
Both output transformers secondaries are wired in series
MUR860 x4 full wave bridge rectifier for the HV DC output
IRFP460 x4 H-bridge output for the AC output
1000uF 250V Chemi-Con KMG (fake) x2 in series for the HV DC output
1000uF 35V for the low voltage control supply
PIC16F716 microcontroller (not code protected ) for sinewave generation/AC output regulation
Note to moderator/admin: I believe that this topic should be a sticky.
On each of the output transformers at the primary side:
2x HRF3205 MOSFETs on each side of the centre tap
2200uF 16V x2
30A fuse x2
On the isolated secondary side:
Both output transformers secondaries are wired in series
MUR860 x4 full wave bridge rectifier for the HV DC output
IRFP460 x4 H-bridge output for the AC output
1000uF 250V Chemi-Con KMG (fake) x2 in series for the HV DC output
1000uF 35V for the low voltage control supply
PIC16F716 microcontroller (not code protected ) for sinewave generation/AC output regulation
Note to moderator/admin: I believe that this topic should be a sticky.
Comment