Re: Replacing OST caps on Microstar KT6 Delta motherboard
ta,
upon further inspection in the daylight, the motherboard now has a pit in it, and the left pad that the cap was soldered to, is no longer there
(have put a better photo on that webpage link)
that vid only applies if there is two pads already there.
i get a continuity between those two metal (they look white on the photo) bits on the left, and the motherboard earth at the metal circles around the board mounting holes
also, i'm now going to remove the 16v and test each of them with the analogue multimeter.
ta,
upon further inspection in the daylight, the motherboard now has a pit in it, and the left pad that the cap was soldered to, is no longer there
(have put a better photo on that webpage link)
that vid only applies if there is two pads already there.
i get a continuity between those two metal (they look white on the photo) bits on the left, and the motherboard earth at the metal circles around the board mounting holes
also, i'm now going to remove the 16v and test each of them with the analogue multimeter.
Comment