Good day folks. I'm not a gadget guy by any means and only know some very basics about phones and tablets, so I'm asking for a bit of help here. I've got this phone called Lesia Note X, some sort of knock-off, doesn't really matter since it may apply to other phones of this kind as well, which gets stuck on the logo screen. If I try to hold the power button and the volume up key, instead of the recovery menu showing up like with other phones, I get "Supported API: 3" in the bottom-left corner and that's it. To make matter worse, at no point is this guy being detected by the computer. When I plug the cable in, I DO get a "hardware attached" notification, but then before anything even shows up, I get a "disconnected" sound, so no devices show up in device manager, not even an unknown one, so this is bricked to hell...
There's very little resources on this "API: 3" issue and even less about this phone. From what I've seen, it appears to be similar to a ZTE phone, but couldn't find any resources on unbricking it. If I could at least get it to stay connected, maybe we can work from there, but it doesn't. It's not a cable issue, as the interval between the connection and the disconnection is always the same and charging works fine... so if anyone's got any ideas, they would be greatly appreciated. Thank you.
There's very little resources on this "API: 3" issue and even less about this phone. From what I've seen, it appears to be similar to a ZTE phone, but couldn't find any resources on unbricking it. If I could at least get it to stay connected, maybe we can work from there, but it doesn't. It's not a cable issue, as the interval between the connection and the disconnection is always the same and charging works fine... so if anyone's got any ideas, they would be greatly appreciated. Thank you.
Comment