I got yamaha rx v675, it have no sound , i already done factory reset but still no change. i checked zone 2 line output ., there i am getting sound ,
Announcement
Collapse
No announcement yet.
Yamaha RX-V675, No sound
Collapse
X
-
Re: Yamaha RX-V675, No sound
You tried going though the diagnostic options and see if that picks any thing up ?.
I would check the front panel for dry joints, would all so check if analog and digital are effected though different rear ports too.
I cannot really help you but thought i would try at least.Last edited by AsRock; 12-08-2017, 04:05 PM.
Comment
-
Re: Yamaha RX-V675, No sound
Originally posted by mmartell View PostDSP/DTS IC has failed many times in Onkyo, Harman etc maybe the case here.
Yes that would not surprise me, seems to be a common issue with AV HDMI devices and typically due to heat.
In some cases people have heated up the DTS chip to get it working, replacing it will not be any fun at all.
Comment
-
Re: Yamaha RX-V675, No sound
Originally posted by srt1 View PostHii i replced the dsp chip but still no sound ,when i am updating firmware its failing and showing error code 0010 also i check in daignostic menu its showing dsp bus NG ,same as before..what will be the couse
Comment
-
Re: Yamaha RX-V675, No sound
Would like to revive this topic.
Currently working on my Yamaha RX-V673 which also has infamous D80YK113CPTP4 DSP IC. When PCBA is bent or small portion of heat applied (e.g. hot air) to the IC, DSP is OK (viewing via Service Mode, C category, DSP1 BUS: OK/NG) and NG when cooled.
Has anyone tried replacing to a new D revision chip from aliexpress? Not quite sure whether DSP IC is bad itself or cracks in tracks/vias.
Comment
Comment