Testing VRMs on A7N8x rev 2

[darylsutor]

I'm using Akor's method for testing vrms on my a7n8x.
https://www.badcaps.net/forum/showthread.php?t=600

I'm at step 3 and measuring resistance from my power pins on motherboard to the input of the VRMs. Should I be worried that I see a small amount of resistance. Akor mentions with new caps there should be no resistance but is that just an anal or ideal measurement????

[cmosbios]

Re: Testing VRMs on A7N8x rev 2

set your ohmmeter to higher range and check again. and it should get 0 very low resistance. to accurately check the component being tested remove it from the circuit board and do a FET regulator test.