Ps4 ADP-240AR power supply

[imboss]

Morning All,

I'm trying to repair power supply after roach did it's magic to it. There are two ceramic caps (C24 & C19) both 1nF. I found schematic but do not know what voltage they must be. Please advise if you should know.

Kind regards

Trevor

[stj]

post the schematic so we can see how the caps are used please.

[imboss]

Here's what I have.

[stj]

shit.
they are in series across rectified mains.
so if you have 220-240v in capetown then your looking at about 360v!!!!
and you need "headspace" so each cap would need to be rated at 250v atleast IMO.

[imboss]

Originally Posted by stj

shit.
they are in series across rectified mains.
so if you have 220-240v in capetown then your looking at about 360v!!!!
and you need "headspace" so each cap would need to be rated at 250v atleast IMO.

Thanks for the information. Greatly appreciated.
Could you please tell me what value R11 is I see its wire wound but bands not correlating to meter Shows 0.06 ohms

A3B827C9-3B77-4237-BF06-DAACDAD17023.jpg

[stj]

maybe 0.027?
its pretty safe to say it's o.k. given your reading and the fact that few meters will be acurate that low

[imboss]

Originally Posted by stj

maybe 0.027?
its pretty safe to say it's o.k. given your reading and the fact that few meters will be acurate that low

Thanks for reply. Time to buy new ps. I've officially run out of talent.