I am working on one of the LED strips from UN55E6150, that has the LEDs that stick out, see attached image.
I have played around with similar LED strip some time ago with no real success.
Going at it from the top with heat gun melts the LED chip and its neighbors.
Going at it from behind does not seem to heat it up enough to melt the solder.
There is not enough room with the soldering iron to go at the solder points on the bottom of the chip.
How do I go about removing and replacing one of those?
I have played around with similar LED strip some time ago with no real success.
Going at it from the top with heat gun melts the LED chip and its neighbors.
Going at it from behind does not seem to heat it up enough to melt the solder.
There is not enough room with the soldering iron to go at the solder points on the bottom of the chip.
How do I go about removing and replacing one of those?
Comment