Hi
I have a Netegear Gs116v1 that had swollen caps, symtoms
I replaced the swollen caps but i think that that pads were corroded before i could do anything
I plugged the power without anything connected in the switch and works but on boot up only the first 14 lights flash and not all of them.
Also sometimes the lights do not flash when i plug in the power but all the ports work ok
I was wondering if someone could confirm this is normal and share a schematic diagram for this switch PCB or tell me where i solder a wire from the two caps to another point
The two caps are PCE6 AND PCE8
The ratings for these are 470uF, 16V
It turns on without these caps
Please can some help
Many Thanks
I have a Netegear Gs116v1 that had swollen caps, symtoms
I replaced the swollen caps but i think that that pads were corroded before i could do anything
I plugged the power without anything connected in the switch and works but on boot up only the first 14 lights flash and not all of them.
Also sometimes the lights do not flash when i plug in the power but all the ports work ok
I was wondering if someone could confirm this is normal and share a schematic diagram for this switch PCB or tell me where i solder a wire from the two caps to another point
The two caps are PCE6 AND PCE8
The ratings for these are 470uF, 16V
It turns on without these caps
Please can some help
Many Thanks
Comment