Hi Guy's, ive got a valiant boiler & these are prone for the control boards failing, causing the boiler to go into a error state.
When you run the hot tap, it goes into the error state but then when you reset, these work fine until next time.
Im convinced that the problem with the boards are something simple like a relay which would cost considerable less than replacing the complete board at several hundred pounds.
I was wondering if anyone had ever done any work or knows of anything to do with boiler boards?
Many thanks in advance
ASH
When you run the hot tap, it goes into the error state but then when you reset, these work fine until next time.
Im convinced that the problem with the boards are something simple like a relay which would cost considerable less than replacing the complete board at several hundred pounds.
I was wondering if anyone had ever done any work or knows of anything to do with boiler boards?
Many thanks in advance
ASH
Comment