Badcaps.net Forum
Go Back   Badcaps Forums > Troubleshooting Hardware & Devices and Electronics Theory > General Electronics Technical Discussion
Register FAQ Calendar Search Today's Posts Mark Forums Read

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-25-2012, 05:45 AM   #1
link988
New Member
 
Join Date: Aug 2011
Posts: 8
Default Circuit voltage measurement problem.

Hi

I got an issue with power supply section of my plasma TV. When turned on it seem to get green light like its starting and after like 10 sec goes to blinking red.

I opened up the unit and started pinpointing the culprit so found when TV just switched on at point where it supposed to be 400V to LLC_SUPPLY it goes up to 380V and decreases to about 140V then a relay click and blinking light appears voltages just gradually continues to drop. I traced it to bridge rectifier and got 230V on pin 2 when tv in that 10 sec period and goes to 0 when red light starts blinking. The question is on pin 3 is the Volatge supposed to be 230V as well, as arrows show that it is an input as well? (its probably me not understanding how to measure it maybe? I measured it the same way as pin 2. DMM to AC setting and black to good ground and red probe to pin 2 and pin 3)





Is that AC2 line supposed to be 0V or I am making very stupid mistake when measuring it? Any help or advice please

Thank you.
Attached Images
File Type: jpg Untitled.jpg (320.0 KB, 61 views)
File Type: jpg Untitled2.jpg (238.9 KB, 60 views)
File Type: jpg Untitled3.jpg (345.7 KB, 60 views)
link988 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



Badcaps.net Technical Forums 2003 - 2019
Powered by vBulletin ®
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
All times are GMT -6. The time now is 06:00 AM.
Did you find this forum helpful?