Diode Identification

[boomtheroom]

Trying to attempt to repair my sc board TNPA5335 BG
found a bad diode at d618 but cant determine its values..can anyone help please?

[dick_barton]

Re: Diode Identification

If you can post it in focus, it would help to identify it.


Edit
Is this a continuation of your other thread and if so would have been better to have stayed on that thread.?????
If it is then from your previous thread it's marked C08N25 and a search on the internet bring them up.

There's also some information on this Mosfet in the following thread

[boomtheroom]

Re: Diode Identification

If you can post it in focus, it would help to identify it.


Edit
Is this a continuation of your other thread and if so would have been better to have stayed on that thread.?????
If it is then from your previous thread it's marked C08N25 and a search on the internet bring them up.

There's also some information on this Mosfet in the following thread

its the one in the bottom left with d618 marked next to it

[R_J]

Re: Diode Identification

It could be a RF101L4S, Panasonic pt# B0ECKP000055, but I might be wrong

[boomtheroom]

Re: Diode Identification

anything from here do as a replacement?

https://www.jaycar.co.nz/active-comp...vance&show=All

[tvtimmy]

Re: Diode Identification

Is Q600 still blown apart? You will get all sorts of bad readings with bad parts still on the board.

[boomtheroom]

Re: Diode Identification

Is Q600 still blown apart? You will get all sorts of bad readings with bad parts still on the board.

yep it sure is.. but d618 is the only diode showing a short

[jetadm123]

Re: Diode Identification

yep it sure is.. but d618 is the only diode showing a short

Just remove D618 and check it out of circuit.

[boomtheroom]

Re: Diode Identification

Just remove D618 and check it out of circuit.

will do!

[tvtimmy]

Re: Diode Identification

It could be reading bad because of the bad Q600 is still on the board.

[Moreno83]

Re: Diode Identification

Trying to attempt to repair my sc board TNPA5335 BG
found a bad diode at d618 but cant determine its values..can anyone help please?

I use Fairchild ES1G as a substitute however that one always reads short on the board. After the fake parts usually the 2/3 diodes top right on the board fail ( close to the white prong connector ).

[boomtheroom]

Re: Diode Identification

I use Fairchild ES1G as a substitute however that one always reads short on the board. After the fake parts usually the 2/3 diodes top right on the board fail ( close to the white prong connector ).

Any idea of an alternative for the 2 chips?
Can't get them from monitor9 so need alternatives
Chers