QFU1.1ELA
Difetto : Errore 53
Telaio / Versione : QFU1.1E LA
Power Supply : FSP197-4FS01 2722 171 90676 REV : 01
Pannello : LTA550HQ19
Main board : 3104 308 98314
T-CON :
Processore : Fusion P240 FNP202-B1E32
7JA0 : MT29F8G08ABABA Flash Nand
The TV is completely turned off.
The voltages I read are 3v3s = 3v3 and STB = 3v1
I reprogrammed the spiflash 7CT3 (M25P10),
on pin 2 of connector 1M95 the power supply
it has gone to a low logic level, from 3v1 to 0 volts.
The 12 volt, now, is present,
like the other feeds on the mainboard.
But I get error code 53.
I tried connecting to Hyperterminal at the service jack,
I get this information (see attachment)
I also enclose the Spi 7CT3 reading before programming.
The trash, which I reprogrammed for SPI is for a processor,
is a Fusion P240 FNP202-B1E32.
Can this be the problem?
Another question, why do I get this log with Hyperterminal?
Difetto : Errore 53
Telaio / Versione : QFU1.1E LA
Power Supply : FSP197-4FS01 2722 171 90676 REV : 01
Pannello : LTA550HQ19
Main board : 3104 308 98314
T-CON :
Processore : Fusion P240 FNP202-B1E32
7JA0 : MT29F8G08ABABA Flash Nand
The TV is completely turned off.
The voltages I read are 3v3s = 3v3 and STB = 3v1
I reprogrammed the spiflash 7CT3 (M25P10),
on pin 2 of connector 1M95 the power supply
it has gone to a low logic level, from 3v1 to 0 volts.
The 12 volt, now, is present,
like the other feeds on the mainboard.
But I get error code 53.
I tried connecting to Hyperterminal at the service jack,
I get this information (see attachment)
I also enclose the Spi 7CT3 reading before programming.
The trash, which I reprogrammed for SPI is for a processor,
is a Fusion P240 FNP202-B1E32.
Can this be the problem?
Another question, why do I get this log with Hyperterminal?
Comment