Announcement

Collapse
No announcement yet.

Fixing a pealing PCB contact

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Fixing a pealing PCB contact

    I know these happen to be ground pins, so bypassing it would be easy
    buy is the proper way to glue them down, if so what kind of glue, supper glue, hypoxy, etc.?
    Attached Files

    #2
    Re: Fixing a pealing PCB contact

    with decent epoxy.

    Comment


      #3
      Re: Fixing a pealing PCB contact

      CircuitWorks CW2500 as used in this video looks good stuff
      https://www.youtube.com/watch?v=vx50YtEC2S8
      Last edited by vinceroger69; 08-13-2018, 02:24 PM.

      Comment


        #4
        Re: Fixing a pealing PCB contact

        Originally posted by vinceroger69 View Post
        CircuitWorks CW2500 as used in this video looks good stuff
        https://www.youtube.com/watch?v=vx50YtEC2S8
        Yes, it's good stuff, but not cheap.

        Comment


          #5
          Re: Fixing a pealing PCB contact

          So would JB Weld Kwik or original be ok to use?
          https://www.amazon.com/J-B-Weld-8276.../dp/B0006O1ICY
          https://www.amazon.com/J-B-Weld-8265.../dp/B0006O1ICE
          I have both on hand

          i could use some electrical tape to keep it off the other contacts and then clamp (tape would protect pcb from clamp) it and let it sit a day and use some rubbing alcohol to get any tape glue off
          or would that just be a bad way to do it?

          Comment


            #6
            Re: Fixing a pealing PCB contact

            being edge connectors i would try superglue . should only need pushing onto socket once. whatever you use it needs to be very runny so it is very thin .

            Comment

            Working...
            X