Had this thing laying around for a bit so I thought I would drag it out under the current global circumstances and see if I can repair it. I have recorded my readings on the image below indicating basic layout and some voltage readings. I am not an EE but I know NOT to mess with the large cap.
EDIT: Cathode is top terminal of Main Cap.
All votlages taken on secondary side were to ground or "neg" in the image.
Essentially the primary side is charging to 370ish. I do have 5v on pin 11.
Grounding pin 4 (green) while small fan and two SATA drives are connected for a load while probing.
Visually I cant see anything that looks out of the ordinary. The empty holes on the primary side were sucked out inspecting they are n/c by design.
Anyone have any ideas where I might look given this information? I have not looked at the small vertical board (image below).
EDIT: Cathode is top terminal of Main Cap.
All votlages taken on secondary side were to ground or "neg" in the image.
Essentially the primary side is charging to 370ish. I do have 5v on pin 11.
Grounding pin 4 (green) while small fan and two SATA drives are connected for a load while probing.
Visually I cant see anything that looks out of the ordinary. The empty holes on the primary side were sucked out inspecting they are n/c by design.
Anyone have any ideas where I might look given this information? I have not looked at the small vertical board (image below).
Comment