Hi everyone. I've got an iPhone 7 with no power. I'm not too familiar with phone board issues would appreciate a little guidance if you can please.
When connected to my PSU is cycles between0.007 to 0.178
With charger connected to lightning i get no voltage on battery connector.
Battery connector plus to negative no short. while charging stuck at .44a no change with new power button flex and charging fles.
phone is recognised in itunes when i put it into dfu mode
Positive terminal diode reading is.478
tested the digi fpc in diode mode comparing with bv measurements
Pin 1 says 505 im getting 263
Pin 3 says 573 I'm getting 245
Pin 25 says 746 im getting OL (looking at bv its not supposed to be ol)
any guidance would be immensely appreciated please!
When connected to my PSU is cycles between0.007 to 0.178
With charger connected to lightning i get no voltage on battery connector.
Battery connector plus to negative no short. while charging stuck at .44a no change with new power button flex and charging fles.
phone is recognised in itunes when i put it into dfu mode
Positive terminal diode reading is.478
tested the digi fpc in diode mode comparing with bv measurements
Pin 1 says 505 im getting 263
Pin 3 says 573 I'm getting 245
Pin 25 says 746 im getting OL (looking at bv its not supposed to be ol)
any guidance would be immensely appreciated please!
Comment