View Single Post
Old 02-21-2020, 02:10 PM   #41
philbo_baggins
New Member
 
Join Date: Feb 2020
City & State: Winston-Salem
My Country: United States
I'm a: Knowledge Seeker
Posts: 1
Default Re: Using my CH341A.

Quote:
Originally Posted by newguy90 View Post
I successfully read and wrote in circuit the 93c56 and 93A56 EEPROM's. I didn't have to power on the circuit, I just used the SOIC8 test clip with the interface
that I built!
I could not use the CH341a though, so I have no use for that interface... at least for now.
newguy90, I am working through a similar problem that you did, do you mind doing a quick writeup of what you did to get this to work? It sounds like you didn't use the CH341 usb programmer/software, but connected directly to the chip through a serial port? I wasn't sure where the drawing you redlined came from, or if that was the final version that you used. Thanks.
philbo_baggins is offline   Reply With Quote