View Single Post
Old 05-03-2019, 01:58 PM   #4
Retro-Hipster
Tinkerer
 
Retro-Hipster's Avatar
 
Join Date: Apr 2019
City & State: Salt Lake City
My Country: United States
Line Voltage: 120VAC 60Hz
I'm a: Hobbyist Tech
Posts: 101
Default Re: IP camera mod/upgrade

AH, Alright. Sorry, I thought you meant that the option was greyed out.

Well, you may be able to do the thing where you find another camera that uses that chip and go off it's schematic, though that could be difficult. I found the Hardware Design Guide here, but it doesn't show the actual pinout of the chip from what I can see. Section 12-72 looks promising though!
http://support.hkvstar.com/file/Hi35..._Datasheet.pdf

From what I can see I would expect the set up to be pretty easy, given the build in MMC/SDCard interface. If you look at the SD card pinout below, you can see that it kind of looks like the setup would be not too hard to get through if you had the pinout of the chip. (Maybe would need a level shifter and/or some resistors between the MCU and SD card reader.)
https://thingiverse-production-new.s...ard-pinout.png
__________________


“Men always seem to think about their
past before they die, as though they were
frantically searching for proof that they
truly lived.”
– Jet (Cowboy Bebop) -

Last edited by Retro-Hipster; 05-03-2019 at 02:28 PM..
Retro-Hipster is offline   Reply With Quote