I have a really nice and clean Sammy PN60E550D1F... Initial checks indicated it was a bad Main Video Board.. Bought a replacement board...
No luck..
Symptoms are:
At power up, the LED blinks several times and then goes out. Normal, I assume..
There are no Sammy StartUp tones..
When I push the power button a few times, I start to get ButtonPush tones..
On VS (marked) I get 210V that quickly counts down to 15V
The Control Board LED (marked) blinks slowly.. 3sec off, 7sec on... 3sec off, 7sec on...
That's all I have so far...
No luck..
Symptoms are:
At power up, the LED blinks several times and then goes out. Normal, I assume..
There are no Sammy StartUp tones..
When I push the power button a few times, I start to get ButtonPush tones..
On VS (marked) I get 210V that quickly counts down to 15V
The Control Board LED (marked) blinks slowly.. 3sec off, 7sec on... 3sec off, 7sec on...
That's all I have so far...
Comment