I have that board for few years ago. She died suddenly and there was not a way to revive.
That evening I found it in a box by chance, looking for a replacement mobo for someone.
Thanks to the knowledge gained here on the forum, I immediately found the cause: VRM Q4 was dead.
I noticed that the two areas in figure remained united after vrm desolder. Is there a risk if the two zones are united? I tried to clean the area, but my soldering iron is pretty skinny.
VRM Q5 is 70L02H, what is best equivalent that I can use?
Thanks.
That evening I found it in a box by chance, looking for a replacement mobo for someone.
Thanks to the knowledge gained here on the forum, I immediately found the cause: VRM Q4 was dead.
I noticed that the two areas in figure remained united after vrm desolder. Is there a risk if the two zones are united? I tried to clean the area, but my soldering iron is pretty skinny.
VRM Q5 is 70L02H, what is best equivalent that I can use?
Thanks.
Comment