View Single Post
Old 08-31-2018, 03:11 AM   #14
Gammaray
Senior Member
 
Join Date: May 2010
My Country: U.S.A.
Posts: 120
Default Re: Electron Kinetics Eagle 2C amplifier problem

Quote:
Originally Posted by petehall347 View Post
tape up your meter probes so just the tip is showing ..this is for when you slip ..
on those outputs B should be about + or- 600mv .
C rail voltage + - same voltages as across each of those big caps .
E should read very low mv.s ..ideally 0v but rarely is the case .
Hi Pete! I'm really kind of a noob here, so please forgive any noob type questions. I don't have a degree in electronics, but I do find this very interesting. I just know a little, but would like to improve my knowledge to get a better understanding of trouble-shooting these components to fix them.

So, that being said, it is my understanding from budm to use my DMM to check resistance and voltages. I should use my ground probe to the green wires on the filter caps, then start checking the Sanken transistors for voltages using the red probe. I assume that I should check the 3 pins that are on these transistors?
I'm not really sure what you are saying when you say check outputs B, and C rail voltage and E?
Gammaray is offline   Reply With Quote