View Single Post
Old 08-29-2018, 10:23 AM   #5
Gammaray
Senior Member
 
Join Date: May 2010
My Country: U.S.A.
Posts: 120
Default Re: Electron Kinetics Eagle 2C amplifier problem

Well I did try and check both big caps after taking them out and I have read where you can set the DMM on around 2000K ohms and with the probes one way the ohms will rise, then with the probes the opposite way, the ohms will decrease. I'm not sure if this works well or not, but one cap does that, and the other one does not. That's why I wanted to be certain that both caps were good!

If I do put the big caps back in and connect them, it will be difficult to test voltages. Perhaps I should do the resistance check first? If so, am I only going to be reading the values on all of the resistors?

Thanks!
Gammaray is offline   Reply With Quote