View Single Post
Old 07-20-2016, 01:38 AM   #39
jarapunga
New Member
 
Join Date: Jan 2015
City & State: Kwekwe
My Country: Zimbabwe
Line Voltage: 220-230VAC 50Hz
I'm a: Knowledge Seeker
Posts: 6
Default Re: How a plasma display panel (PDP) works

I noticed this thread while searching for a solution to a problem on an lg 42pt350 where both y-sus and z-sus boards had shorted igbits. I replaced the igbits but they all shorted again after the priming stage. I'm now on a quest as to why these same igbits have failed twice. Is it possible that I have a short inside the PDP module which is damaging these igbits?? According to Tom's article, the pdp module has an array of electrodes with gas in between. No chance for a short there?? Any opinions??
jarapunga is offline   Reply With Quote