that whole unit is mitsubishi.
i can tell by looking at the board pics.
if both tubes are running swap them on the inverter and see what it does.
had a mitsubishi in here last month that was sick at power up and improved slightly after 10 minutes of warmup.2 new ccfl tubes later it looks new again.
can you tell me what to do about the rubber bits at the end of the tube, am i supposed to ease them back to enable desoldering of tube or is it going to be impossible? it is rather difficult.
also what kind of tape to use to secure wire to back of mirror, is normal electrical tape fine?
i carefully slice the heatshrink and peel it off.those white rubber blocks absob impacts and are hv insulation.also make sure the reflective film is still stuck to the metal.if it curls you get uneven lighting.
the heat does in the glue.
Comment