When I turn mine on, the power light goes green, and I can't see an image or a backlight. After the customary amount of time has passed, the power light will turn to amber and the backlight will activate. After a few seconds that backlight will go out.
I can change the behavior of the backlight and power LED by adjusting the contrast. I'm not sure if I can do so by adjusting the brightness.
I'm aware of an issue with ICE2AS01. During some discussion offline, I was told this circuit essentially regulates all of the power going to the monitor, so if I'm getting SOME power, then the issue could lie elsewhere.
I just want to confirm the capacitors on this thing are good enough for government. When I opened it up, I failed to find any capacitors whose tops have blown, and I don't believe I found any with electrolyte oozing from the bottom.
Thanks for reading!
I can change the behavior of the backlight and power LED by adjusting the contrast. I'm not sure if I can do so by adjusting the brightness.
I'm aware of an issue with ICE2AS01. During some discussion offline, I was told this circuit essentially regulates all of the power going to the monitor, so if I'm getting SOME power, then the issue could lie elsewhere.
I just want to confirm the capacitors on this thing are good enough for government. When I opened it up, I failed to find any capacitors whose tops have blown, and I don't believe I found any with electrolyte oozing from the bottom.
Thanks for reading!
Comment