View Single Post
Old 05-04-2018, 11:15 PM   #25
budm
Badcaps Veteran
 
budm's Avatar
 
Join Date: Feb 2010
City & State: S.F. Bay area
My Country: USA
Line Voltage: 120V 60Hz
I'm a: Knowledge Seeker
Posts: 34,693
Default Re: BenQ Q22W6 Capacitor Replacement

If the board has four lamps, one pair for top edge, and another pair for the bottom edge then you will disconnect one of the two pair of the lamp and put the test lamps and fire up the board to see if the lamps will stay on, if it does then you know that one set of the original is good.
There is possibility of have one bad lamp in each pair of lamp assembly, so you will need 2 pair of test lamps or you can try using combination of lamps hookup to narrow down but that takes too much time for me, I have many test lamps so it is not a problem for me to use all 4 test lamps first to verify that the power supply/inverter board is good or bad.
__________________
Never stop learning
Basic LCD TV and Monitor troubleshooting guides.
http://www.badcaps.net/forum/showthr...956#post305956

Voltage Regulator (LDO) testing:
http://www.badcaps.net/forum/showthr...999#post300999

Inverter testing using old CFL:
http://www.badcaps.net/forum/showthr...er+testing+cfl

Tear down pictures : Hit the ">" Show Albums and stories" on the left side
http://s807.photobucket.com/user/budm/library/

TV Factory reset codes listing:
http://www.badcaps.net/forum/showthread.php?t=24809

Last edited by budm; 05-04-2018 at 11:21 PM..
budm is offline   Reply With Quote