Re: Homemade Uniden CB antenna replacement
It quite possibly could be metric indeed. However it seems to mesh with 32tpi SAE thread feeler and both NF and NC (28 and 24 TPI respectively) do not mesh. A 6-32 screw meshes fine too, at least it looks like it holds flat against the wall as far as I can see.
I found that my air compressor screw-on blow gun nozzle tip will thread into this thing. And a Schrader valve cap will thread onto the blow gun nozzle!
I wonder if there are any other common things that will thread onto a Schrader valve cap?
|