Badcaps Forums - View Single Post

**televizora** · 01-13-2021, 12:39 PM

Just command the hazard lights via relay, while supplying them 12V directly from the battery. Use the original electrical wiring as control signal for the relay, then commutate 12V from the battery. So when you turn them on, they work. Then use a second relay, so you can command them via the alarm. So when either the alarm sends a signal to the relay to close or turn them on, they will work.
You need 2 relays and 1 plus wire from the battery.

01-13-2021, 12:39 PM	#8
televizora ghettomodmaster Join Date: Nov 2016 City & State: Bulgaria My Country: Bulgaria Line Voltage: 230VAC 50Hz I'm a: Student Tech Posts: 824	Re: 4017 counter reset problem Just command the hazard lights via relay, while supplying them 12V directly from the battery. Use the original electrical wiring as control signal for the relay, then commutate 12V from the battery. So when you turn them on, they work. Then use a second relay, so you can command them via the alarm. So when either the alarm sends a signal to the relay to close or turn them on, they will work. You need 2 relays and 1 plus wire from the battery. __________________ Useful conversions. I don't "speak" imperial. Please use metric, if you want to address me. 1km=1000m=100000cm, 1inch=2.54cm, 1mile=1609.344meters, 1ft=30.48cm 1gal(US)=3.785liters, 1lb=453grams, 1oz=28.34grams Last edited by televizora; 01-13-2021 at 12:50 PM..