Re: Sony XBR-65X810C Not Powering on
Hello,
Reading these posts has helped me to get to this point.
I have a Sony XBR65810C, its completely dead.
I can get all the voltage outputs from the Power board.
So at this point I have 2 leads, there
I used the Service Manual from ELECTROTANYA site that someone kindly shared.
I need help interpreting the next steps on this troubleshooting tree.
I've completed steps highlighted in yellow, (see attached picture).
but I don't know what "Check OPWRSB R9179" and then the next step is "Check STBY_MHL R9179" these are referring to the same resistor but what does OPWRSB and STBY_MHL mean.
ALso the following steps
"Check POWER_ON
P-on ucom #pin19
Is the voltage >3.0V?"
Please see attached Picture.
Thanks again for getting me this far.
Hello,
Reading these posts has helped me to get to this point.
I have a Sony XBR65810C, its completely dead.
I can get all the voltage outputs from the Power board.
So at this point I have 2 leads, there
I used the Service Manual from ELECTROTANYA site that someone kindly shared.
I need help interpreting the next steps on this troubleshooting tree.
I've completed steps highlighted in yellow, (see attached picture).
but I don't know what "Check OPWRSB R9179" and then the next step is "Check STBY_MHL R9179" these are referring to the same resistor but what does OPWRSB and STBY_MHL mean.
ALso the following steps
"Check POWER_ON
P-on ucom #pin19
Is the voltage >3.0V?"
Please see attached Picture.
Thanks again for getting me this far.
Comment